Відео

Only kind of related. I got an amplifier in a trade a few weeks ago. It is a headphone amp but also a 1 watt speaker amp. It uses 6AS7g tubes. I was surprised how much power I can get from one watt. It drives my speakers very well. Anyway, my local military warehouse store is closing its doors soon. Right now it is in the 'make an offer' stage before the auction. I bought a box full of old pull RCA 6as7g Bendix 6080 tubes for $50. A few tested bad but what a nice deal.

Do you know by any chance where to download the latest firmware for the kit?

there are 2 very different connectors thats how

Is the cup replaceable?

Dang, this is an awesome explanation of how these devices work and should be configured! Thanks for the video.

Hi, this is the future! Considering running fiber to be future-proof at this juncture. But since I have attic access, going to run Category-8 cable for all the second-floor drops off of an unmanaged 10GB switch - in the attic. Why not, right? It adds to the value ofbthe house. How ‘bout some single-network access points for WiFi, too.

What about if you do not have coax in your walls? I have Directv, but the coax is not running throughout the house, just to the tv.

Is you coax cable grounded? I believe my coax cable only grounds when connected to the powered splitter in the cable box. Whereas, the coax I'll be using will be "dead" coax and so I don't think will be grounded. I had to connect two coax in the cable box together via a 3Ghz dual female connector. Though I guess I could look into getting like a grounding clamp and run a wire to the ground wire, or just hook up it up the powered splitter and put a MOCA filter on the incoming cable, as my MOCA adapter can be used with a cable signal.

I believe there are MOCA adapters that let you run it on coax that has a cable signal.

A few Questions: My house is wired with coax cables all individually terminating to a splitter in the garage. I use Verizon Fios internet and the ONT box is in the garage. This limits me to having my modem/wifi router located in the garage which gives me degraded wifi signal where my TV is located. If I use the GCA-7000 to transfer my signal through coax, can I connect the ethernet cable directly to the ONT box and move my modem/router to a location better suited for good wifi in the house? Or should I connect the ethernet to the modem/router in the garage instead? In this situation could I use a second wifi router within the house to improve the wifi signal? Thanks for any assistance and advice.

One of the best how-to videos on a topic I didn't know existed.

So what if you have fiber internet that's delivered over an optical cable going into your modem instead of coaxial, will this still work?

Mine seem to reduce vibration. Made sound thicker.

Feels like a slight difference. Maybe good to use when rolling and then go without once you’ve landed on preferred option.

Thanks for this video, the moca works like magic 🙏🏻 this video was made for me I only needed 2 rooms and it’s awesome

Any cheaper adapter?

If the router has coax going to it already do I instead plug it into the Moca and then the Ethernet to the router? Or do I need a splitter and need to run both. Thank you

I can’t just buy a cable that is a coax to Ethernet and hook the Ethernet to my ps5 and get an internet connection ?

I have a fender 68 custom twin reverb amp..would the sovteks b compatible?

Moved into a house last year, about 1500 square-foot, no ethernet ports but coax cable connections in each of the three bedrooms and living room. Has spectrum Internet service. I get great Wi-Fi speed on everything, when I do Speedtest on my phone, or Apple TV, I get the full Wi-Fi speed that I'm supposed to be getting, but not on gaming consoles, I have been thinking of getting a cable in my bedroom for PS5. Sounds like this might work?

Great explanation, finally found one that makes sense. Thanks! 😊

if everyone knew this is a treassure in the history of music accross the ages. WOW!

Thank you, just picked up a used DV and enjoying the fun of tube rolling.

I'm too not realy sure if its placebo, but I can swear on my left earlobe that without it I feel a bit punchier/vibraient sound from all frequencies, a bit more warmth, aggression - like a small screen mesh that keep some of the sound away with the saver. Totally minut but I'd leave without one after this vid, thanks for sharing!

Great video, could hear some differences with the 3. don’t think Utube can do this test true justice, I have heard a distinct difference and prefer the TungSol with a Chesky HQ CD tho. I believe you did as well as platform allows !! Nice job

SCOTTY KILMER says NEVER install one of these-- says the cold air injection will RUIN the engine- and other issues... ... COMMENtS on that>>? I'm thinking of buying a CX-50 naturally aspirated engine instead of the turbo because 1- I don't like the lag and 2- they're known to cause over heating issues and can ruin an engine- 3- they DO wear the engine out sooner 4- I drive short distances not long trips- and not that much.. IDEAS???

dude! finally presented in a way that made me understand what the fuck I was trying to learn!! the diagrams and commentary of the different TYPES of coaxial setups people can have! BUT, still no one I have found has clearly explained that an adapter is NOT needed if the modem/router is MoCA compatible!!!! Then I only need one damn adapter in the room that I need to convert coaxial to ethernet!!! why did this take me so long to find today!!!!!!

Im confused, I live in a townhome right? So I don’t have a basement, can I keep the modem connected and just use a splitter?

My house was built in 2020. It has 2 coax ports but they don’t seem to be live? Any advice

You can use MOCA adapters and cable tv over the same coax network. Cable TV uses frequencies on the coax cable of under 1000 mhz while MOCA uses 1100-1600mhz, generally. Also, be aware that most cable TV providers install cheap coax splitters that only pass thru frequencies under 1000 mhz. This can stop MOCA signals from moving thru the wiring. You can buy splitters that go up to 2000 mhz and these should be used for MOCA networks. These numbers are usually on the front of the splitters and easy to check.

Would anyoner know if the adapter can then lead onto another modem for ESSENTIALLY a new access port??

For the coax that would normally go out to the modem, can I put a coax splitter from the wall with one coax into the modem and one coax into the adapter? The modem will plug into a router via ethernet (yellow port) and the parallel adapter will plug into the same router via ethernet (other available port). I'd rather do this to prevent the adapter from being a single point of failure to my modem and want to see if it is possible to configure my setup this way? Thanks!

I would defy anybody to listen to this demo without knowing/seeing the tube changes and prove they hear a difference.

But. What dictates whether the coax is for tv or internet?

This is great if your coax cables are in the house. My house the cables are on the outside next to power, TV etc. behind seperate wall panels. Good video though.

Paul, your content, production and editing are first class! I can tell you take great effort. Good for you sir!

Hello, I have a question: I live in a small apartment behind my landlords larger house. He has a Spectrum cable box, modem, and wifi router towards the front of his house, (There's an additional Spectrum cable box in my bedroom for my TV, on his same account). I use his wifi signal to connect my bedroom laptop to the Internet, but the signal is very weak, even with an extender I purchased and connected. So my question is this: would it be as simple as just splitting the coaxil cable that goes into my cable box and connecting a 3rd party modem for a legitimate strong Internet signal which I can run to my laptop with an Ethernet cable? Thank you.

At 15.30 instead of using a switch connector for multiple ports is it possible to plug into a router for wifi connection? Will that still work?

Thank you so so much!! The explanation about the version of not having access to room by room Coax runs, really helped, with the explanation of a splitter. Not all apartments give access to the runs from a central loation to their dedicated endpoints like an MDF or IDF. 🙌💯🔥

I have just found a 6SN7 to 6922 converter (for my WA3), and there is also a 6SN7 to 6922. Could there be any significant change in the DarkVoice going to a 6922 Gold Lion?

No one seems to talk about how I can use the coax in the room that that needs to connect to the coax to receive the connection to the modem in the first place

I recently bought a radio with tubes so full of old cigarette smoke the tubes weren't even clear anymore. You couldn't even see inside them. The only way to clean them included rubbing off the lettering. I mean they were sticky dirty and even touching them to pull them smeared the silkscreen. Don't know if there's a way to preserve them or not when they are this bad.

stock has deeper low end. I collect and test many 6as7/6080 tubes. I find the coke bottle ones have deeper bass and the smaller dome 6080 are tighter

i have a question. My house is build like this in your video with coax box where are the exits from all the rooms. Sooo.... what would be if i connect them all together, and i connect one end to the router antenna :D Would i be able to see the signal maybe then in all rooms?

If you have a splitter box in the basement and have all the old coax plugged into them can you run a single coax to ethernet converter to the whole box so that it goes to each room? That way no matter which room you go to if you have a converter plugged In there will be internet available?

Your video saved me! Our modem was installed in the basement. router is on first floor. Worked for a while, then stopped recently. Couldnt get it working using Customer support. I strung a 100' ethernet cable from basement to router, and it worked fine, but couldn't find an easy way to get it thru walls/floor. I read about Coax to Ethernet adapters and gave it a try, since we have unused coax thruout house. I got 2 Hitron MoCa 2.5 adapters. I watched a bunch of videos and couldnt get it working. Found you video, which clearly and logically laid out how this type of system works and communicates. You were also the first to explain how older splitters often wont pass the MoCa 2.5 signals. I ditched the 2 splitters in the path, and it instantly worked!! I think I could have gotten older cheaper non-MoCa adapters, and it might have worked, even with the splitters. Thanks for all the great information, presented in such a clear way.

Loved the video But my set-up in my home is a little different. My modem and Asus mesh router are located in my living room. My home has coaxial and ethernate thru out the house. But my coaxial cables are located in my laundry room by my garage. How can I the moca work for me. I'm new at this.

Almost the same 😅 bass slam, details … almost identical 😩

this is the most simplified video i've found. Ordering my pieces now

This video is perfect!!!!